The Tampa Connected Vehicle Pilot Program investigates damage to roadside units (RSUs) near lightning strikes and improves transient surge immunity by verifying nearby support structures are properly grounded.

Success Stories from the USDOT’s Connected Vehicle Pilot Program.

Tampa; Florida; United States

Background (Show)

Lesson Learned

One of the program goals is to resolve technical deployment issues. During one year of continuous testing, the THEA Pilot found that four of the forty-four installed roadside units (RSUs) were not communicating with the Master server. After a series of investigations, THEA concluded that some RSUs were not grounded properly and that lightning strikes were causing damage to the RSUs. The THEA Pilot resolved the issues after replacing the RSUs and properly grounding them. The following paragraphs detail the investigation process performed by the THEA Pilot’s RSU vendor.

The first set of THEA’s RSUs was installed prior to November 2017. Following roughly a year of operation, four RSUs were found to not be broadcasting messages and were reported as "Configured in Master Server, but not communicating with RSU". The RSUs were disassembled and each electronic assembly was tested. The Power over Ethernet (PoE) Splitter, an electrical subassembly that splits the Ethernet transmit data pair (TX+, TX-) and receive data pair (RX+, RX-) from 48 VDC that powers the RSU, was found to be damaged by electrical surge. This damage may leave the RSU powered but not communicating which matches the indication at the Master Server.

The PoE Splitter was examined and found to be damaged by exposure to excessive voltage entering the Ethernet connection from the PoE Injector located inside the roadside electrical cabinet. Because no similar symptoms were reported from installations of identical equipment, local conditions in Tampa were investigated next. Each RSU was found to be installed and bonded to the mast arms correctly according to the vendor installation instructions. Lightning damage from direct hits to antennas or to the RSU itself was ruled out, as no damage to any electronic subassemblies attached to exposed antennas was observed. Next, the metal structures supporting the RSUs as well as nearby metal structures, such as poles, were examined. Some were found to be bonded to the ground, while some were not. Based on the analysis, the investigation concluded the root cause to be lightning strikes to ungrounded metal structures where the arc introduces a voltage surge entering the RSU at the Ethernet connector. The Ethernet connector is attached directly to the PoE Splitter electronic subassembly mounted inside the RSU. When damaged, the PoE Splitter ceases communications to the Master Server, which initially reported that condition. Upon realizing this, THEA replaced the PoE splitter for all four RSUs – resulting in the RSUs returning to normal functionality again.

The figure below graphically depicts the issue. Cloud-to-ground lightning strikes seek the path of least resistance (i.e the ground connection on each structure). When grounded (no green "X"), the strike is contained. When left ungrounded as shown by the green "X", the next least path of resistance to earth ground is through 120VAC servicing the PoE Injector, continuing through the PoE Splitter of the RSU while seeking the ground of the RSU. That path of least resistance from the ungrounded structure through the RSU is shown as the two red arrows of the figure, likely an air-gap arc shown.

Lesson Comments

No comments posted to date

Comment on this Lesson

To comment on this lesson, fill in the information below and click on submit. An asterisk (*) indicates a required field. Your name and email address, if provided, will not be posted, but are to contact you, if needed to clarify your comments.


Connected Vehicle Pilot Deployment Program: Success Stories

Author: Glassco, Rick; James O'Hara; Barbara Staples; Kathy Thompson; and Peiwei Wang

Published By: USDOT Office of the Secretary for Research and Deployment

Source Date: 11/01/2017

URL: https://www.its.dot.gov/pilots/success_lessonslearned.htm

Other Lessons From this Source

Lesson Contacts

Lesson Analyst:

Kathy Thompson


Average User Rating

0.7 (11 ratings)

Rate this Lesson

(click stars to rate)

Lessons From This Source

Allow for increased coordination with the Interdepartmental Radio Advisory Committee (IRAC) early on in the DSRC licensing process to help reduce what is traditionally a very lengthy process.

Connected Vehicle Pilot Deployment Program yields program management best practices for integrating and testing large disparate systems.

Connected vehicles should rely on more than one data feed to determine accurate location and speed

Consider installing additional vehicle detection equipment if it is determined that there is not sufficient market penetration for CV traffic signal control applications to work at their full potential

Facing a gap in standards interpretation, the Tampa and New York City Connected Vehicle Pilot Sites worked together to harmonize message structure for pedestrian safety applications.

For pedestrian safety warning applications, opt to collect pedestrian location data from LIDAR sensors instead of pedestrian mobile devices that often have insufficient accuracy.

Incentivize participation in CV deployments through benefits such as toll discounts

Include technical, operations, and legal personnel in stakeholder meetings to address the requirements of the CV deployment and ensure that participants' privacy is being maintained

Incorporate standardized over-the-air update procedures to permit efficient firmware updates for connected vehicle devices.

Obtain working prototypes of CV applications from the USDOT’s Open Source Application Data Portal (OSADP) to prevent time spent doing duplicative software development

Prevent the need for channel switching (a safety hazard) by designing CV communications to include dual radios in each vehicle

Publish all CV planning documentation to serve as an example for other early deployers to follow

The Tampa Connected Vehicle Pilot Program investigates damage to roadside units (RSUs) near lightning strikes and improves transient surge immunity by verifying nearby support structures are properly grounded.

The USDOT’s three Connected Vehicle Pilots successfully demonstrate cross-site over-the-air interoperability among six participating vendors.

Use local student mechanics where possible to perform CV equipment installations to provide students with required trainee experience and to contain costs

Use on-board connected vehicle (CV) technology and SPaT / MAP infrastructure messages to prevent wrong way entries on reversible express lanes.

When installing antennas on streetcars to support wireless connected vehicle applications, verify that radio performance is not compromised by interference from high-voltage power lines.

Lesson ID: 2019-00916