Cost

A dual protocol road-side unit (RSU) providing both cellular and dedicated short-range communication (DSRC) technologies can be deployed for approximately $6,000 per intersection.

The Texas Department of Transportation (TxDOT) examines various strategies to improve operations and network efficiency using smart transport technologies.


July 2018
Nationwide; United States


Summary Information

This project developed and demonstrated a variety of smart-transport technologies, policies, and practices for highways and freeways using connected autonomous vehicles (CAVs), smartphones, roadside equipment, and related technologies.

Autonomous intersection management (AIM) was discussed for networks with connected automated vehicles (CAVs) and human-driven vehicles (HVs). The strategy included a reservation-based protocol in which CAVs could request to reserve trajectories crossing an intersection using a “first come, first served? (FCFS) policy, and an automated intersection manager would approve the reservation requests only if it did not conflict with any previously approved reservation or an HV.

The AIM protocol did not rely on communication capabilities between vehicles (V2V) but only between vehicles and the intersection manager (V2I). The protocol was robust to communication failures: if a message was lost, either by the intersection manager or by the CAV, the system’s efficiency may have been reduced, but safety was not compromised. Safety was guaranteed also when considering a mixed scenario where both HVs and CAVs were present.

SYSTEM COST

With respect AIM, Hybrid-AIM, or D-tolling, the most critical piece of hardware necessary is a roadside unit (RSU) capable of supporting V2I communication. Cost data from one source suggests that a RSU providing both cellular and DSRC communication technologies can be deployed for approximately $6,000 per intersection. In addition to providing sufficient communication capabilities for implementing AIM or H-AIM, this solution may also provide data on travel times over a road segment.

Alternatively, a traditional signal controller that provides network communications may be suitable to support H-AIM. The Siemens M60 advanced traffic controller (ATC) which is capable of running Linux and features a minimum of two network interfaces was estimated to cost $5,000, which in most use cases is sufficient to control a single intersection. This model can be found commonly in the field where newer traffic controllers have been installed.


System Cost Comments

No comments posted to date

Comment on this System Cost

To comment on this summary, fill in the information below and click on submit. An asterisk (*) indicates a required field. Your name and email address, if provided, will not be posted, but are to contact you, if needed to clarify your comments.



Source

Bringing Smart Transport to Texans: Ensuring the Benefits of a Connected and Autonomous Transport System in Texas (Phase 2)—Final Report

Author: Kockelman, Kara et.al.

Published By: Texas DOT

Source Date: July 2018

Other Reference Number: FHWA/TX-18/0-6838-3

URL: https://library.ctr.utexas.edu/ctr-publications/0-6838-3.pdf

System Cost

Dual protocol RSU (Cellular and DSRC): $6K per intersection.

Rating

Average User Rating

0 ( ratings)

Rate this System Cost

(click stars to rate)


Related Unit Cost Subsystems

Roadside Telecommunications (RS-TC)

Keywords

coordinated signals, signal coordination, centralized signal control, signal synchronization, traffic signals, advanced signal control, signal timing optimization, coordinated signal control, advanced signal controller, traffic signal retiming, retiming

Cost ID: 2019-00437